How do you give Meropenem IM?

Meropenem for Injection, USP should be administered by intravenous infusion over approximately 15 minutes to 30 minutes. Doses of 1 gram may also be administered as an intravenous bolus injection (5 mL to 20 mL) over approximately 3 minutes to 5 minutes.

How is Meropenem 1g IV prepared?

A solution for infusion is prepared by dissolving the drug product in either 0.9% sodium chloride solution for infusion or 5% dextrose solution for infusion to a final concentration of 1 to 20 mg/ml.

How fast can Meropenem be given IV?

aeruginosa, a dose of 1 gram every 8 hours is recommended. MERREM IV should be administered by intravenous infusion over approximately 15 minutes to 30 minutes. Doses of 1 gram may also be administered as an intravenous bolus injection (5 mL to 20 mL) over approximately 3 minutes to 5 minutes.

What rate do you run Meropenem?

The recommended dose of Meropenem for Injection USP and Sodium Chloride Injection USP is 500 mg given every 8 hours for skin and skin structure infections and 1 gram given every 8 hours for intra-abdominal infections.

Why is meropenem given over 3 hours?

Conclusions: Compared with conventional regime of 30-minute infusion of meropenem in the treatment of HAP in ICU patients, the clinical efficacy can be improved, the severity of the disease can be reduced, the recovery of organ failure and long-term prognosis can be improved with 3 hour extended infusion of meropenem.

How do you give an imipenem injection?

Imipenem and cilastatin injection comes as a powder to be mixed with liquid to be injected intravenously (into a vein) or intramuscularly (into a muscle). When imipenem and cilastatin is injected intravenously, it is usually infused (injected slowly) over a period of 20 minutes to 1 hour every 6 or 8 hours.

How do you give an IV injection?

How it works

1. Inject a needle into the person’s vein.
2. Push a small plastic catheter over the needle and into the vein.
3. Remove the needle, leaving the catheter in place.
4. Place an access cap over the catheter, which allows them to administer medications without having to re-inject a needle.

How do I reconstitute meropenem 500mg?

A solution for infusion is prepared by dissolving the drug product meropenem in either 0.9% sodium chloride solution for infusion or 5% glucose (dextrose) solution for infusion to a final concentration of 1 to 20 mg/ml.

Can you give meropenem IV push?

Meropenem is usually given by intravenous infusion over approximately 15 to 30 minutes (see section 6.2, 6.3 and 6.6). Alternatively, doses up to 1 g can be given as an intravenous bolus injection over approximately 5 minutes.

Why meropenem is given slowly?

Studies have suggested that a smaller dose given over a longer period of time, results in blood levels of meropenem that are just as good as when a higher dose is given over a shorter period of time.

Why use meropenem extended infusion?

Meropenem exhibits time-dependent antimicrobial activity and prolonged infusion (PI) (extended infusion or continuous infusion, EI or CI) of meropenem can better achieve pharmacodynamics target when comparing with intermittent bolus (IB).

What is meropenem 500 mg?

meropenem 500 mg/50 mL in 0.9% sodium chloride intravenous piggyback. Meropenem is used to treat a wide variety of bacterial infections. This medication is known as a carbapenem-type antibiotic. It works by stopping the growth of bacteria.

Can imipenem be given intramuscular?

Intramuscularly administered imipenem/cilastatin was effective, generally well tolerated, and resulted in cost saving. Intramuscular administration of imipenem/cilastatin may be a preferred antibiotic treatment in patients with mild to moderate infection due to susceptible microorganisms.

How do you reconstitute IV antibiotics?

Reconstitute a 1 g vial and a 2 g vial each with 10 mL of sterile water for injection • Administer each 1 g dose by slow IV push over 3 to 5 minutes. Administer each 2 g dose by slow IV push over 3 to 5 minutes. minutes. Local thrombophlebitis can occur.

How do you give a pan 40 injection?

PD Pan 40mg Injection is best taken 1 hour before a meal. You should avoid spicy and fatty foods while taking this medicine. You must refrain from caffeinated drinks such as tea, coffee and cola. Alcohol intake should also be avoided as it may worsen your symptoms.

Should meropenem be refrigerated?

Meropenem as the trihydrate in elastomeric administration devices displays reasonable stability at lower concentrations (6 mg/mL and 12 mg/mL), under refrigerated conditions (6.7°C).